Is your crane grounding being monitored properly? Since 1985, Engineered Systems has serviced crane systems. They wanted a safer system to ensure the bridge and trolley were grounded, so they reached out to Bender.
Modern overhead electric cranes are used in many different industrial and commercial facilities. They are typically powered via connection to three-phase rails and one ground rail that is suspended along their beams. They assert pressure on the conductive rails and allow for the flow of power from a source to the moving bridge that holds the trolley and hoist. The crane drive and idler wheels ride on metal beams and are usually in good contact with electric ground. In some applications materials such as dust and fibers are produced and present in the air. Over time these contaminants build up and can cause higher contact resistance or lack of connection to ground.
Image 1 shows a crane rail and dual-shoe connection system. This cradle is suspended from the moving bridge and the shoe holders and arms assert upward pressure on the shoes while they slide back-and-forth along the power rails. Over time, the connections and mechanisms can develop connection issues, which can affect the performance of the system. For instance, If the ground connection is lost there may not be any noticeable issue, but there is certainly a safety concern, since the trolley may not be adequately grounded. A ground fault on the trolley could energize the crane frame – leading to a touch potential hazard.
The right solution for this application is the LINETRAXX® GM420. The GM420 is a loop monitor that is typically used to monitor ground bonding to fixed equipment. It takes measurements by injecting a small DC current to measure the resistance of the loop. Engineered Systems was able to install a second shoe arm to the bridge, which had to be added to allow two connection points to the ground rail, creating an electrical loop. With that second contact point, the GM420 can monitor the circuit to ensure proper crane grounding and make the system safer for plant personnel. Additional information on the GM420 can be found here.